CUSTOM WORKS

NEW adjustable Toe Rear A-arms for the B6.1 and B6.1 Conversion cars.Custom Works Patented thumb screw adjustment makes these the easiest and fastest way to adjust your rear toe. Both sides capable...

Custom Works TrueSpeed machined spur gear.

Beach RC says... spur gears are available in a variety of sizes to tune your car for specific track conditions. Includes one 48 pitch spur.

Beach RC says... This is a replacement for the Intimidator 7, Enforcer 7, Outlaw 3 and Rocket Stage 3 kits. Includes ten shims.  New Part# CSW1255 

Beach RC says... This is  GSX MOTOR MOUNT SCREWS (4)  

each RC says... This is a replacement for the Enforcer 7 and Outlaw 3 kits. Includes one clear lexan front wing mount with factory applied overspray film. 

This is a  Custom Works X-tra short front suspenion arm for an Enforcer and Intimidator kit

Beach RC says... This is a brass weight that mounts on same hole centers as battery strap mounts so it can be mounted in any battery mount option holes or can be mounted below battery strap mount if...

New CVA collars for the cars using hex axles (Outlaw 4 and Rocket 4.) These can be installed to keep the cross pin from "escaping" from the assembly if the set screw comes loose. We will also be...

Custom Works Aluminum wing mount buttons anodized black (2)  

Custom Works Aluminum Short Servo Mounts. This is a replacement for the Enforcer 7 kits. Package includes two short aluminum servo mounts.   

Custom Works Front Axle. This is a replacement for the Intimidator 7, Enforcer 7, Outlaw 3 and Rocket Stage 3 kits. Package includes one axle, one spacer and one set screw.   

This is a replacement Custom Works Outlaw 4 Shorty Battery Strap, including both hook and loop sides. 

Custom Works 2-3/8" titanium turnbuckles (2)

Custom Works Steering Bellcrank Kit. This is a replacement for the Intimidator 7, Outlaw 3 and Rocket Stage 3 kits. Package includes the bellcrank, rod ends, ball studs, bearings, shims and hardware.

7" x 7" VORTEX SPRINT CAR TOP WING Comes with Mounts to fit all Sprint Cars kits using the V2 cage (#3430) This includes Outlaw 3 and 4 Enforcer 6 and 7 and most sprint car conversion kits for...

Custom Works RC DOMINATOR KIT FIberglass Chassis Kit.

Custom Works 4.5 x 3" Large Front Wing. This is a replacement for the Outlaw 3 kits. Package includes one clear clear front wing assembly with factory applied overspray film, and assembly hardware...

Custom Works Brass Spur Gear Hub

BRASS LOW PROFILE SERVO MOUNT

BRASS WEIGHT 1 OZ.

1.75OZ STEEL BATTERY WEIGHT

5MM REAR AXLE

CVA KIT (FITS OUTLAW 4 & ROCKET 4)

CVA BONE FOR OUTLAW 4 / ROCKET 4

Custom Works Steering Extender for Hex Spindles

Custom Works Outlaw 4 Transmission Brace - Carbon Fiber

Custom Works Front Axle Hex Spacer (3MM Offset)  - (1) pc

Custom Works Front Aluminum Axle With 12MM Hex (5MM Offset)

Custom Works 12MM Clampint Hex for 5MM Axle (5.5MM Offset)