The Novak 1S LiPo Booster Module (#5477) is for single-cell racing; it replaces the receiver battery pack and will provide a constant 6 volts and 3 amps of power to the receiver and servo in your race set-up. This module connects to your main battery pack and will actually "boost" the battery pack's 3-4 volts to a standard 6 volts for the duration of the run-- which allows the receiver and servo to operate as they are intended to. There is no need for special wiring or recharging of a receiver battery pack. Simply connect the module's power wires to the main battery pack or the ESC's battery terminals, and plug the harness into your receiver's battery slot.

The Novak 1S Booster Module easy to connect, extremely small and lightweight. It is compatible with brushless or brush speed controls that would normally operate with a 2-3S LiPo pack. By increasing the battery pack voltage to the receiver and servo, the module allows you to use any radio receiver in single-cell applications, including spread spectrum radios. The usual voltage fluctuations that cause reception issues with your radio using 1S LiPo packs are no longer a concern. It is recommended to use the Novak Glitch Buster Capacitor (#5626)with 2.4GHz radio systems to ensure trouble-free operation.

Note: This unit replaces the Smart Boost 1-Cell Step-Up Module (#5474). Our new 1S Booster Module (#5477) does not include LiPo cutoff circuitry.

Features:

Increases a 1-cell Li-Po battery pack's voltage from 3.3V - 4.2V to 6V, which provides enough power to run almost any servo or receiver

Provides consistent power to vehicle's electronics during the entire charge

On/Off Switch for clean installation and easy operation

Universal JST Plug that fits all popular brand receivers

Compatible with brushless and brush speed controls