TRAXXAS

This is a Traxxas Complete LED Light Kit with a High-Voltage Power Amplifier (TRA6590).    

This is the electric powered, 2.4GHz radio controlled, ready to run 1/16 scale Traxxas Slash Short-Course Racing Truck.FEATURES: Chassis: Nylon composite construction 0.08" (2mm) thick bathtub type...

Traxxas GTR Shock Spring. These are the silver, 4.9 rate springs. Traxxas offers a wide variety of spring rates for the GTR shocks to precisely compensate for lighter or heavier truck configurations...

This is a replacement Traxxas Variable Damping Kit, intended for use with the GTR shocks. This kit includes twelve shock pistons and four flat metal plates.   

The Traxxas TRX-4 Sport is purpose built for trail-conquering RC fun with innovative technical features and rugged durability. The new TRX-4 Sport Unassembled Kit combines all the technical...

This is a replacement Traxxas black Chassis.

These are the optional 1.5° Aluminum Rear Stub Axle Carriers from Traxxas. FEATURES: Machined aluminum construction Anodized red in color INCLUDES: Two Aluminum Rear Stub Axle Carriers Two...

These are the optional 1.5° Aluminum Rear Stub Axle Carriers from Traxxas. FEATURES: Machined aluminum construction Anodized green in color INCLUDES: Two Aluminum Rear Stub Axle Carriers Two...

This is a Traxxas Painted & Decaled Flame Body for the Bigfoot No.1 Officially Licensed Replica.    

This is the Traxxas battery and charger pack. Includes: 8.4V 3000mAh 7-cell battery (TRA2926X) 2-amp NiMH peak detecting AC charger (TRA2969) Note: The battery and charger are for models...

This is the BATT/CHGER COMPLETER 2869 by Traxxas - Traxxas BATT/CHGER COMPLETER 2869

This is a replacement LaTrax Front & Rear Bulkhead/Differential Housing Set. Package includes the plastic upper and lower front differential bulkhead and rear differential bulkhead components...

This is a Traxxas Front/Rear Steel Center Assembled Constant-Velocity Driveshaft Set for the E-Revo VXL Brushless. These Constant Velocity Driveshafts are designed to handle the extreme...

This is a replacement Traxxas ESC/Receiver Mounting Plate, intended for use with the installation of the Traxxas XL-5 or XL-10 Electronic Speed Control's and Waterproof Receiver Box into the Traxxas...

This is a set of optional 30 Degree Pink Caster Blocks for the Traxxas Rustler and Stampede. FEATURES: Anodized aluminum construction Pink in color 30 degree INCLUDES: One left and right 30 degree...

This is a pack of two replacement Traxxas 17x26x5mm Ball Bearings. These bearings feature a black rubber seal to keep in the lubrication and keep out the dirt.   

This is a replacement Traxxas Axle Carrier Set. Set includes a left and right side carrier.   

This is the brushless electric powered, 2.4GHz radio controlled, ready to run 1/10 scale Traxxas Slash 4x4 Short Course Racing Truck with TSM (Traxxas Stability Management). Features: Traxxas...

This is a replacement Traxxas Unlimited Desert Racer GTR Shocks Rebuild Kit. This kit includes x-rings, bladders, piston nuts, and shock rod ends; enough parts to service two shocks.   

This is a replacement Traxxas Plastic Servo Gear Set for use with the Traxxas 2070 and 2075 servos. Also included are two bearings. However, before you consider replacing stripped plastic gears with...

This is a replacement Traxxas Metal Gear Set for the Traxxas TRA2070 and TRA2075 servos.   

This is an optional Traxxas Metal Gear Set for the 2070 and 2075 Traxxas Servos, but a a replacement part for the Traxxas 2075X servo. Also included is gear grease, which should be applied during...

Traxxas VXL-6s Motor and ESC combo used in the 6s vehicles.  

Motor, 2200Kv 75mm, brushless (with 6.5mm gold-plated connectors & high-efficiency heatsink)

This is a replacement motor with pinion gear for the EZ-start 2 starting system for Traxxas Vehicles. This is the main drive motor for the EZ-start 2 system, so if your motor goes bad you can replace...

This is a optional Traxxas Exo-Carbon wing with included decal sheet, and is intended for use with the Traxxas 1/16 E-Revo.  

This is a replacement Traxxas Shim Set. This set is intended for use when trying to adjust the roll center on the Jato. Package also includes hollow balls used for the inner camber links...

These 2.2" wheels for Bandit fit Traxxas and other standard 2.2" buggy tires. Tracer 2.2" wheels are available in a shiny mirror-chrome or sinister black-chrome.

This is a set of two replacement Traxxas Tracer 1/10 Buggy Front Wheels, and is intended for use with the Traxxas Bandit. These 2.2" wheels for Bandit fit Traxxas and other standard 2.2" buggy tires...

This is a pack of two replacement LaTrax Rear Axle Carriers.