TRAXXAS

This is a replacement Traxxas Low Profile Wing Mount Set.   

This is a set of replacement planet gears, and shafts from Traxxas. These are the gears and shafts that reside inside the differential assembly.  

This is the Aluminum Center Driveshaft for the Traxxas Slash 4x4 Vehicles. FEATURES: Hollow aluminum construction Anodized green in color   INCLUDES: One Aluminum Center Driveshaft...

This is a replacement Traxxas Differential CV Output Drive Kit, used to connect the differentials to the front or rear half shaft assemblies on the Traxxas Summit Monster Truck. Made from machined...

This is a replacement Traxxas Sealed Receiver Box Kit, intended for use with the Traxxas Electric Rustler, Stampede and Bandit vehicles. Includes: Receiver Box (1) Foam Pads (2) 2.5x8mm Cap...

Traxxas Rustler 4X4 Battery Hold Down. Package includes one replacement battery hold down.   

Jato is designed to be able to use sway bars. All the mounts and connectors are already integrated into the suspension arms and bulkheads. Installation is a snap. Sway bars reduce chassis lean and...

This is a replacement Traxxas Half Shaft Joint Re-Build kit, intended for use with the Traxxas Summit Monster Truck. This kit contains the hardware to connect the stub axles and output drives to the...

This is a Traxxas Complete LED Light Kit with a High-Voltage Power Amplifier (TRA6590).    

Traxxas GTR Shock Spring. These are the silver, 4.9 rate springs. Traxxas offers a wide variety of spring rates for the GTR shocks to precisely compensate for lighter or heavier truck configurations...

This is a replacement Traxxas Variable Damping Kit, intended for use with the GTR shocks. This kit includes twelve shock pistons and four flat metal plates.   

This is a replacement Traxxas black Chassis.

These are the optional 1.5° Aluminum Rear Stub Axle Carriers from Traxxas. FEATURES: Machined aluminum construction Anodized red in color INCLUDES: Two Aluminum Rear Stub Axle Carriers Two...

These are the optional 1.5° Aluminum Rear Stub Axle Carriers from Traxxas. FEATURES: Machined aluminum construction Anodized green in color INCLUDES: Two Aluminum Rear Stub Axle Carriers Two...

This is a Traxxas Painted & Decaled Flame Body for the Bigfoot No.1 Officially Licensed Replica.    

This is the Traxxas battery and charger pack. Includes: 8.4V 3000mAh 7-cell battery (TRA2926X) 2-amp NiMH peak detecting AC charger (TRA2969) Note: The battery and charger are for models...

This is the BATT/CHGER COMPLETER 2869 by Traxxas - Traxxas BATT/CHGER COMPLETER 2869

This is a replacement LaTrax Front & Rear Bulkhead/Differential Housing Set. Package includes the plastic upper and lower front differential bulkhead and rear differential bulkhead components...

This is a Traxxas Front/Rear Steel Center Assembled Constant-Velocity Driveshaft Set for the E-Revo VXL Brushless. These Constant Velocity Driveshafts are designed to handle the extreme...

This is a set of optional 30 Degree Pink Caster Blocks for the Traxxas Rustler and Stampede. FEATURES: Anodized aluminum construction Pink in color 30 degree INCLUDES: One left and right 30 degree...

This is a pack of two replacement Traxxas 17x26x5mm Ball Bearings. These bearings feature a black rubber seal to keep in the lubrication and keep out the dirt.   

This is a replacement Traxxas Axle Carrier Set. Set includes a left and right side carrier.   

This is a replacement Traxxas Unlimited Desert Racer GTR Shocks Rebuild Kit. This kit includes x-rings, bladders, piston nuts, and shock rod ends; enough parts to service two shocks.   

This is a replacement Traxxas Plastic Servo Gear Set for use with the Traxxas 2070 and 2075 servos. Also included are two bearings. However, before you consider replacing stripped plastic gears with...

This is a replacement Traxxas Metal Gear Set for the Traxxas TRA2070 and TRA2075 servos.   

This is an optional Traxxas Metal Gear Set for the 2070 and 2075 Traxxas Servos, but a a replacement part for the Traxxas 2075X servo. Also included is gear grease, which should be applied during...

Traxxas VXL-6s Motor and ESC combo used in the 6s vehicles.  

Motor, 2200Kv 75mm, brushless (with 6.5mm gold-plated connectors & high-efficiency heatsink)

This is a replacement motor with pinion gear for the EZ-start 2 starting system for Traxxas Vehicles. This is the main drive motor for the EZ-start 2 system, so if your motor goes bad you can replace...

This is a optional Traxxas Exo-Carbon wing with included decal sheet, and is intended for use with the Traxxas 1/16 E-Revo.