CUSTOM WORKS

Beach RC says...This is a Custom Works spring set for long MDX shocks with a spring rate of 4lbs. 

Beach RC says...This is a pack of eight Custom Works 4/40 Steel Locknuts, intended for use with Outlaw 4 and Rocket 4 kits.    

Beach RC says...This is a Custom Works spring set for long MDX shocks with a spring rate of 10lbs. For Rocket and Outlaw.

Beach RC says...This is a pack of eight Custom Works M4 Serrated Flanged Wheel Nuts backed by an aggressive serrated surface for ultimate holding power. These nuts are used with 4mm axles, and...

NEW adjustable Toe Rear A-arms for the B6.1 and B6.1 Conversion cars.Custom Works Patented thumb screw adjustment makes these the easiest and fastest way to adjust your rear toe. Both sides capable...

Beach RC says... This is a replacement for the Intimidator 7, Enforcer 7, Outlaw 3 and Rocket Stage 3 kits. Includes ten shims.  New Part# CSW1255 

each RC says... This is a replacement for the Enforcer 7 and Outlaw 3 kits. Includes one clear lexan front wing mount with factory applied overspray film. 

This is a  Custom Works X-tra short front suspenion arm for an Enforcer and Intimidator kit

New CVA collars for the cars using hex axles (Outlaw 4 and Rocket 4.) These can be installed to keep the cross pin from "escaping" from the assembly if the set screw comes loose. We will also be...

Custom Works Aluminum wing mount buttons anodized black (2)  

Custom Works Aluminum Short Servo Mounts. This is a replacement for the Enforcer 7 kits. Package includes two short aluminum servo mounts.   

Custom Works Front Axle. This is a replacement for the Intimidator 7, Enforcer 7, Outlaw 3 and Rocket Stage 3 kits. Package includes one axle, one spacer and one set screw.   

Custom Works Steering Bellcrank Kit. This is a replacement for the Intimidator 7, Outlaw 3 and Rocket Stage 3 kits. Package includes the bellcrank, rod ends, ball studs, bearings, shims and hardware.

Custom Works RC DOMINATOR KIT FIberglass Chassis Kit.

Custom Works 4.5 x 3" Large Front Wing. This is a replacement for the Outlaw 3 kits. Package includes one clear clear front wing assembly with factory applied overspray film, and assembly hardware...

Custom Works Brass Spur Gear Hub

BRASS LOW PROFILE SERVO MOUNT

5MM REAR AXLE

Custom Works Steering Extender for Hex Spindles

Custom Works Outlaw 4 Transmission Brace - Carbon Fiber

Custom Works Front Axle Hex Spacer (3MM Offset)  - (1) pc

Custom Works 12MM Clampint Hex for 5MM Axle (5.5MM Offset)

Custom Works Aluminum Fan Mount for the Outlaw 4 or Rocket 4

Custom Works CVA Rebuild Kit for the Outlaw 4 or Rocket 4

Custom Works Speed  Control Riser for the Outlaw 4

Custom Works Crush Tube For 5mm Axle (2) for the Outlaw 4 or Rocket 4

Custom Works Rear Molded Hex (4) for the Outlaw 4 or Rocket 4

Custom Works Drive Pin For Hex Axle (6) for the Outlaw 4 or Rocket 4

Custom Works Trailing Steering Block For Hex Axle (2) for the Outlaw 4 or Rocket 4 or car with Hex Conversion  

Custom Works Inline Steering Block For Hex Axle (2) for the Outlaw 4 or Rocket 4 or car with Hex Conversion